Instructions for Installation and Use 2110UK/EN 13240 · (72% Efficiency)Distributed by: Morsø UK · Valley Drive · Swift Valley · Rugby, Warks CV21 1TW
10ENG5. Refuelling of your stove should be done while there are still glowing embers in the bed. Spread the em-bers across the bottom, but concentrat
11ENG Comparison between wood-burning and oil-burningType of wood (moisture content 20%) No. of cubic metres per 1000 litre of oilOak 7.0Beech 7.0A
12ENG3.1 External maintenanceThe surface of the stove is painted with heat-resistant Senotherm paint. If the stove is used too vigorously, the painte
13ENGReasons for premature wear of internal parts- Stove being used/fired too vigorously - Too much air passing through the bottom grate- Use of exce
14ENG 4.0 Alternative fuel typesYour new Morsø stove is EN-approved for burning wood.However, the stove is capable of burning other solid fuels as ma
15ENGIn order to maintain the combustion process, the entire grate area must remain covered by glowing coals. If the coal layer is too shallow you wi
Morsø Jernstøberi A/S - 2011.12.06 - 72213500www.morsoe.com
2ENGEnjoy your new Morsø stove!Morsø, the largest stove manufacturer in Denmark, has been making cast-iron stoves of the highest quality since 1853.
3ENG1.1 Unpacking the stove2110: After removing the outer packaging, unbolt the combustion chamber from the wooden pallet and place it gently on its
4ENGIn situations where the stove is to be fitted into a brick or non-combustible recess, we recom-mend that the stove is installed with at least 10 c
5ENG1.6 Fluepipe connectionsThe stove comes standard with a flue collar (1) at the top and a cast-iron cover mounted on the cast-iron back panel behin
6ENG1.7 Connecting the stove to a masonry chimneyA wall sleeve should be bricked securely into the wall of the chimney at the appropriate height and
7ENG1.9 Draft conditionsIf smoke spillage occurs when the fire door is opened, it is probably due to poor chimney draft. This type of stove requires a
8ENG2.0 FIRING THE STOVE/USING YOUR STOVE For wood firing, the shaking grate and the door valves should always be closed. Primary air is only used for
9ENG1. A layer of embers will form rapidly if the stove is lit with 2 - 4 fire lighters or 7 - 10 rolled up sheets of newspaper, underneath roughly 1
Comments to this Manuals